Base outage: network halted block production for two hours — team resolved the issue
An incident occurred on the Base Layer 2 (L2) network, leading to a halt in block production for nearly two hours. The project team quickly identified and resolved the malfunction, which was related to consensus issues and the inclusion of an invalid block in the sequence.
According to protocol creator Jesse Pollak, user funds remained completely safe. The incident did not affect assets, although it temporarily disrupted normal network operation.
Notably, the failure happened just a few hours before the planned Beryl upgrade. This is an important event for the Base ecosystem, and the community is now paying close attention to network stability following the incident.
The root cause of the problem was an invalid block that was erroneously included in the sequence. This caused a consensus divergence between nodes, temporarily paralyzing the production of new blocks. The Base team quickly assessed the situation and restored normal operation.
My expert analysis: Such failures are rare but serve as a reminder of the need for constant monitoring and rapid response. For L2 networks striving for scalability and decentralization, such incidents are an inevitable part of evolution. The key point is that user funds were not affected, and the team demonstrated the ability to recover quickly. However, investors should consider that technical risks persist, especially ahead of major upgrades.