In the world of cryptocurrencies, even a minor automation glitch can turn into a catastrophe. A striking example occurred on August 12, when a transaction with a fee of 1.6 BTC—about $102,778 at the current exchange rate—was recorded in block 962,142. The recipient, however, did not see a single satoshi: all the funds went to the miners.

Blockchain analysis shows that the transaction input contained 160,343,885 satoshis, while the only output was empty. This is a classic scenario where the fee "ate" the entire transfer amount.

The root of the problem: automation with Replace-by-Fee

The culprit in this situation is an automated script with the Replace-by-Fee (RBF) function. The RBF mechanism allows replacing an unconfirmed transaction with a new one carrying a higher fee to speed up its processing in the mempool. It is a useful tool during periods of network congestion, when fees surge sharply and payments stall for hours.

However, this time the bot malfunctioned. Instead of stopping at a reasonable level, it increased the fee every second, "draining" more and more funds from the balance. The script failed to account for the possibility that the fee could exceed the transfer amount, and in the end, the sender lost all their funds.

The Bitcoin protocol does not limit the fee size, so miners gladly accepted the transaction. The block was mined by the SpiderPool pool, which received all the satoshis. The total fee in this block was about 1.82 BTC, and 88% of that amount came from a single erroneous transaction. For miners, whose profits have been declining for several months, such a "gift" is a real stroke of luck.

How to protect yourself from such mistakes

This case is a serious reminder of the risks of automation. To avoid such losses, I recommend:

Disable automatic fee increases. Manually confirming each change will force you to check the numbers before sending.

Set a hard fee limit. Most modern wallets allow you to specify a maximum number of satoshis per byte. This limit will serve as a safeguard against uncontrolled growth.

Always conduct a test transfer. A small amount of a few thousand satoshis will show whether the bot is working correctly. This is especially important after every software update.

The situation also raises an important question: should a wallet allow spending all funds on a fee within a single transaction? I think developers should consider introducing protective mechanisms that would prevent such scenarios.

In my view, this case is a vivid example that automation in cryptocurrencies requires no less attention than protecting your seed phrase. An uncontrolled script can empty an account faster than any hacker. Remember: Bitcoin does not forgive mistakes, and the best defense is awareness and manual control at every step.